RAPIDAIR SYSTEMS

RapidAir Home - Garage System

Design an efficient and professional home garage / workshop with the RapidAir Home Garage Kit.
RapidAir is a complete compressed air distribution system that easily installs beneath walls of new construction, or on wall surfaces of existing workshops. With no special installation tools required, you can easily assemble, disassemble, and re-modify your system at any time.

ORIGINAL RAPIDAIR
MASTER KIT

$ 220.00 inc GST

Choose RapidAir Home Garage Compressed Air System for:
Your home garage or workshop
Hobbyist woodworking applications
Powering your personal tools
Easy in wall or on wall installation
Single air users

RapidAir Components

50100

Male NTP to RAPIDAIR

50120

NTP Drain Valve

50125

1/4" NTP to BSP Nipple

50135

1/4" NTP Brass Plug

50200

RAPIDAIR Tee

50300

RAPIDAIR Elbow

50400

RAPIDAIR to NTP Elbow

50500

RAPIDAIR Coupler

90100

RAPIDAIR Outlet Kit

90200

RAPIDAIR Manifold Kit

90120

Bare Wall Mount Block

90220

Bare Manifold Block

20100

30 Mtr Pipe Only Kit

20200

Hose Clip - Pack of 12

INSTALLATION IDEAS

ON WALL

The onwall method is the most common and quickest method, simply layout your pipe and cut and insert dropper fittings as required for each outlet position, then clip to wall or ceiling

IN WALL

The inwall method is the most stylish yet still an easy method of installation, simply layout your pipe and cut as required for each outlet position, then insert pipe in to wall or ceiling cavity and fit retaing clips where necessary

PRODUCT INFORMATION

PIPE SPEC

Size 1/2" O.D - 3/8" I.D. 
Operating working pressure 150 psi @70°F. 
Temperature range -40°F to 180°F.
Compatible with common compressor oils.
Suitable for Internal/Interior Use.
Exterior installation must be protected from U.V.

BENDING SPEC

Bend Radius 100mm(4") to 150mm(6").
The internal & External measurement must be maintained after bending so not to cause restriction - do not exceed the minimum bend radius.
Outside Diameter 12.5mm(1/2")
Inside Diameter 10mm(3/8")

Fitting SPEC

Push to Connect style.
Nickel plated brass and Nylon. 
Oring seal, Buna N.
Stainless steel bite ring. 
No expensive install tools required

FITTING METHOD

Cut Tube ensuring square and clean end.
Check locking collar on fitting is free.
Push tube and fitting together very firmly, bottom pipe out in the base of fitting.
Pull to test/embed bite ring


Download Installation Instructions,Product Brochure,
Warranty Card and Pricelist Here

© Copyright 2019 RAPIDAIR SYSTEMS ( A.B.N: 68 114 319 836 ) - All Rights Reserved